If the Stack Symmetry choice is enabled in the Board section of the Properties panel, layers are added in matching pairs, centered around the mid-dielectric layer. For a inflexible-flex design, layers are also enabled and disabled in this tab. As a normal document editor, the Layer Stack Manager (LSM) could be left open while the board is being labored on, allowing you to change backwards and forwards between the board and the LSM. All of the usual view behaviors, such as splitting the display screen or opening on a separate monitor are supported.

The Layer Stack Manager opens in a document editor in the same method as a schematic sheet, the PCB, and other document types do. The Layer Stack Manager brings together all of those layer-specific design necessities right into a single editor.

In a high pace design, when the barrel of a through extends past the sign layers that the signal is routed on, signal reflections can occur. This can lead to signal degradation and signal integrity points. One method used to resolve this is to drill out the unused via barrels utilizing managed depth drilling, which is a technique additionally referred to as again drilling. Internal copper layers embrace a Copper Orientation possibility which defines the direction that the copper is bonded to the core (and then etched from). Configure this to ensure the impedance calculations are correct.

If any pair of layers that are equidistant from the central dielectric reference layer usually are not equivalent, the Stack just isn't symmetric dialog opens. The selection of layer supplies and their properties ought to always be done in consultation with the board fabricator. The Stackup Tab collapsible part earlier on this web page summarizes the varied techniques obtainable for adding, eradicating, modifying, and ordering the layers.

Note that a Save action must be carried out in the Layer Stack Manager before modifications are mirrored in the PCB. To open the Layer Stack Manager choose Design » Layer Stack Manager from the main menus.

Rigid-flex - rigid-flex boards are configured within the Stackups tab of the Layer Stack Manager. Refer to theDefining and Configuring the Rigid-Flex Substackssection.